MP-24A - 24 Inch Automatic Impulse Sealer - 2mm Seal

Midwest Pacific Automatic Impulse Sealers MP-24A are very heavy-duty, table top, impulse models.  Automatic mode or manual mode can be switched from the console. There are no motors, belts, gears or drive chains to wear out.  In automatic mode, when the machine is turned on it immediately begins to cycle at a cyclic rate that is programmed from the three control dials on the face of the machine. In manual mode, the unit cycles under the control of a foot pedal switch (included).  All Midwest Pacific Automatic Impulse Sealers operate on 110 volt and are double fused.  The Jaw is opened and closed by use of an electro-magnet. They are geared to high volume production or to applications where precise control can easily be maintained even when frequently changing bags sizes and thickness.  These machines are best suited for KEL-F, POLYFLEX, P.V.A., POLYETHYLENE, POLYURETHANE, POLYVINYLCHLORIDE, POLYPROPYLENE, PLIOFILM, TIVAC, SARAN and most other heat sealable materials.  Uses Standard 110V outlet.

Each machine comes with a 90 day warranty on labor and all parts except heating element, upper and lower Teflon. (These parts are consumable - they require replacement over time based on use.) 

The program dials provide control for:
1. The interval that the jaw stays open between sealing cycles. 
2. The interval that the jaw stays closed during sealing cycles. 
3. The length of time the element is hot.

• Maximum Seal Length - 24 inches
• Maximum Material Thickness - 8 mil. 
• Seal Width - 2 mm
• Impulse Power - 800W